peerless98
I Am 4 Ukraine!
- Joined
- Sep 3, 2009
- Messages
- 13,549
- Likes
- 15,274
One suggestion I could give as a woodworker of sorts would be to make a crosscut on the table about 6 inches from the front and hinge it at the back. If you then brace it and create a "basket" for the back hinged portion, a small styrofoam cooler would work. You could then make cutouts in the front 6 inch section for cup/can holders. I hope that makes sense.I actually could put a small cooler where the table is
Yes, thanks for the tip. I think I could pull it off.One suggestion I could give as a woodworker of sorts would be to make a crosscut on the table about 6 inches from the front and hinge it at the back. If you then brace it and create a "basket" for the back hinged portion, a small styrofoam cooler would work. You could then make cutouts in the front 6 inch section for cup/can holders. I hope that makes sense.
Nice!!!View attachment 285283View attachment 285284I built this double chair and table. Just thought I'd share it with fellow Vols!! GO VOLS!!View attachment 285279
I like it, but my OCD will not allow me to look at the picture very longView attachment 285283View attachment 285284I built this double chair and table. Just thought I'd share it with fellow Vols!! GO VOLS!!View attachment 285279