Dumbledorange
Well-Known Member
- Joined
- Nov 3, 2019
- Messages
- 2,665
- Likes
- 1,059
Yeah we have played in a tournament that had a bunch of boards that were awful, not fun. These had good slide to them and little bounce. I got lucky.Very cool! Look very sturdy which is important.
50% of cornhole boards joy of using is in the surface finish (how the bag slides). The other 50% is the stability. Nothing more frustrating than playing on boards that are flexible and poorly constructed.
Thanks!! The endzones were a challenge but I like the way the turned out. Probably was an easier way to do it,but for my first build,I'll take it.Outstanding job. Know your son will get years of enjoyment out of your hard work. Btw nice work on the end zones. You should send a photo to Phil and tell him this is how the end zones are suppose to look like and to just spend the money for the extra paint.
I did checkerboard on a table by getting a strip of vinyl sticker from a sign shop that was 10-12" wide. I stuck it to the table and then drew a checkerboard on it using a pencil with a metal ruler. I cut along the lines with a sharp exacto knife and pulled every other block off. Sealed it with a couple coats of polyurethane and Bob's your uncle.Thanks for the kind comments. First set I've ever built. The checkerboard was a pain but had to do them, took lots of hours. I was worried about the T, had to freehand it because didn't have time to get decal.I think my son will like them, if I still give them to him.
Sounds like good idea. I just drew mine and taped it off to paint. Worked pretty good except where paint would run over the edge a little.I did checkerboard on a table by getting a strip of vinyl sticker from a sign shop that was 10-12" wide. I stuck it to the table and then drew a checkerboard on it using a pencil with a metal ruler. I cut along the lines with a sharp exacto knife and pulled every other block off. Sealed it with a couple coats of polyurethane and Bob's your uncle.